A review of history of CAD/CAM system application in the productionof transtibial prosthetic socket in developing countries (from 1980to 2019)

• Main Authors: Afiqah Hamzah, Nur, Razak, Nasrul Anuar Abd, Sayuti Ab Karim, Mohd, Gholizadeh, Hossein
• Format: Article
• Published: Sage Publications Ltd 2021
• Subjects: TA Engineering (General). Civil engineering (General); TK Electrical engineering. Electronics Nuclear engineering
• Online Access: http://eprints.um.edu.my/26760/
• Institution: Universiti Malaya

The development of the CAD/CAM (Computer-aided design and computer-aided manufacturing) system has globally changed the fabrication and delivery of prosthetics and orthotics. Furthermore, since the introduction of CAD/CAM in the 1980s, many successful CAD/CAM system are available in the market today. However, less than 20% of amputees have access to digital fabrication technology and large portion of the amputees are from the developing countries. This review designed to examine selected studies from 1980 to 2019 on CAD/CAM systems in the production of transtibial prosthetic sockets. A review was conducted based on articles gathered from Web of Science, Pubmed and Science Direct. From the findings, 92 articles found related to CAD/CAM-derived transtibial prosthetic socket (TPS). After a further screening of the articles, 20 studies were chosen and only one study was done in a developing country. The results showed an increase interest in CAD/CAM application in Transtibial prosthetic socket (TPS) production for both developed and developing countries, yet the technology has not fully utilised in the developing countries. Factors such as resources, accessibility, knowledge-gap and lack of experienced prosthetists remain the major causes of the lack of CAD/CAM system studies. Large-scale trials are required to employ digital fabrication in the developing regions, consequently advancing the production of high-quality CAD-CAM-derived TPS where most prosthetic and orthotics are needed.