Preliminary study on the fabrication and characterization of pressure retarded osmosis flat-sheet membranes

• المؤلف الرئيسي: Lim, Jun Yuan
• مؤلفون آخرون: Wang Rong
• التنسيق: Final Year Project
• اللغة: English
• منشور في: 2014
• الموضوعات: DRNTU::Engineering
• الوصول للمادة أونلاين: http://hdl.handle.net/10356/61273
• المؤسسة: Nanyang Technological University

The rapid depletion of natural fuel sources and the ever-growing need for water and energy has raised the concerns to find a sustainable supply for these resources. As a result, Pressure Retarded Osmosis (PRO) process became an attractive option for researchers to work on. Despite this technology being available, development of PRO membranes is needed to utilize the power production. As an osmotically membrane process, PRO process is affected by internal concentration polarization problems, which results in lower effective osmotic pressure. This problem can be mitigated by producing a high porous substrate, however this would reduce the mechanical strength of membrane. In PRO applications, high mechanical strength is required due to hydraulic pressure on the draw side of the membrane. Hence, an efficient membrane must be developed for future application of PRO technology. PRO membrane recipes with different substrates were proposed for this investigation and their performance was evaluated experimentally. Thin-Film Composite (TFC) membranes were made by phase inversion to produce substrate, followed by Interfacial Polymerization (IP) to form a rejection layer on the substrate’s surface. Characterization of the membrane properties were done to investigate the morphology, contact angle, mechanical strength, and separation properties of the membrane. Finally, the PRO performances of the membrane were evaluated. Characterization results showed that the developed PRO membranes had a good selectivity, water permeability and high mechanical strength. Power density of 2.29 W/m2 was attained initially. Enhanced performance was achieved by optimizing the recipes of the substrate. Power density of 3.47 W/m2 and 4.26 W/m2 were shown by the optimized membranes. These results indicated that membranes are promising for PRO applications and further improvement can be made with fine adjustments to produce an effective support.