Study of the effects of EDM parameters on material removal rate , electrode wear rate and surface roughness in the EDM of S-Star

by Mohamed , Konneh
Published 2010

Precision grinding of silicon carbide using 107 µm Grain diamond cup wheel

by Mohamed , Konneh, -, Mohd Fadzil
Published 2011

Precision grinding of silicon carbide using 46 µm grain diamond cup wheel

by Mohamed , Konneh, -, Ahmad Fauzan
Published 2011

Precision grinding of silicon carbide using 76 µm grain diamond cup wheel

by Mohamed , Konneh, Zawawi, Mohd Shukur
Published 2011

Investigation of surface integrity during precision grinding of silicon carbide using diamond grinding pins

by Mohamed , Konneh, -, Mohamad Lutfi, -, Mohamad Shahrilnizam
Published 2011

High speed milling of mould steel using 1.5mm-diameter end-mills

by Mohamed , Konneh, Ahmad, Khairunnisa, Fazleen, Rose
Published 2011

Influence of electrode cooling on recast layers and micro crack in EDM of titanium

by Abdulkareem, Suleiman, Khan, Ahsan Ali, Mohamed , Konneh
Published 2011

Influence of electrode cooling on material migration among the electrodes during EDM of titanium alloy

by Abdulkareem, Suleiman, Khan, Ahsan Ali, Mohamed , Konneh
Published 2011

Reducing electrode wear ratio using cryogenic cooling during electrical discharge machining

by Abdulkareem, Suleiman, Khan, Ahsan Ali, Mohamed , Konneh
Published 2009

Influence of electrode cooling on material migration among the electrodes during edm of titanium alloy

by Abdulkareem, Suleiman, Khan, Ahsan Ali, Mohamed , Konneh
Published 2011

Using the desirability function as an effective tool in target costing model

by Al Hazza, Muataz Hazza Faizi, Mohamed, Konneh, Iqbal, Mohammad, Taha, Assem Hatem, Muhammad, Hasibul Hasan
Published 2015