The effect of tool edge radius on the chip formation behavior of tool-based micromachining

by Woon, K.S., Rahman, M.
Published 2014

Extrusion-like chip formation mechanism and its role in suppressing void nucleation

by Woon, K.S., Rahman, M.
Published 2014

Improving Coolant Effectiveness through Drill Design Optimization in Gundrilling

by Woon K.S., Tnay G.L., Rahman M.
Published 2019

Deep hole drilling methodology for high yield strength Inconel 718 >1000 MPa

by Woon, KS, Chaudhari, A, Rahman, M, Kumar, AS
Published 2019

The effect of tool edge radius on the contact phenomenon of tool-based micromachining

by Woon, K.S., Rahman, M., Neo, K.S., Liu, K.
Published 2014

The Effects of Tool Degradation on Hole Straightness in Deep Hole Gundrilling of Inconel-718

by Woon, KS, Chaudhari, A, Kumar, A Senthil, Rahman, M
Published 2019

Investigations of tool edge radius effect in micromachining: A FEM simulation approach

by Woon, K.S., Rahman, M., Fang, F.Z., Neo, K.S., Liu, K.
Published 2014

Experimental and Numerical Study of the Strength Performance of Deep Beams with Perforated Thin Mild Steel Plates as Shear Reinforcement

by Chai K.F., Woon K.S., Wong J.K., Lim J.H., Lee F.W., Lee Y.L.
Published 2024

Life Cycle Assessment and Techno-Economic Analysis for Anaerobic Digestion as Cow Manure Management System

by Tan, W.E., Liew, P.Y., Tan, L.S., Woon, K.S., Mohammad Rozali, N.E., Ho, W.S., NorRuwaida, J.
Published 2022

Environment impact and bioenergy analysis on the microwave pyrolysis of WAS from food industry: Comparison of CO2 and N2 atmosphere

by Mong, G.R., Liew, C.S., Chong, W.W.F., Mohd Nor, S.A., Ng, J.-H., Idris, R., Chiong, M.C., Lim, J.W., Zakaria, Z.A., Woon, K.S.
Published 2022