MODIFICATION OF A CENTRIFUGE BOTTOM BEARING IN ORDER TO RAISE ITS MEAN TIME BETWEEN FAILURES (MTBF)

MODIFICATION OF A CENTRIFUGE BOTTOM BEARING IN ORDER TO RAISE ITS MEAN TIME BETWEEN FAILURES (MTBF)

Centrifuge is a device in a processing industry used to reduce water content of the terephthalic acid by means of centrifugal force. To generate the centrifugal force in the centrifuge which is the focus of this report, centrifuge has several rotating component in it which are supported by angular c...

Saved in:

書目詳細資料
主要作者:	KESUMA (NIM : 13104089); Pembimbing Utama : Prof. Dr. Indra Nurhadi, HARDY
格式:	Final Project
語言:	Indonesia
在線閱讀:	https://digilib.itb.ac.id/gdl/view/15853
標簽:	添加標簽沒有標簽, 成為第一個標記此記錄!
機構:	Institut Teknologi Bandung
語言:	Indonesia

相似書籍

RELIABILITY ANALYSIS TO DETERMINED MEAN TIME BETWEEN FAILURE(MTBF) CASE STUDY ON PLTU SURALAYA PULVERIZER
由: DESI ANGGRAENI (NIM : 23108020); Pembimbing : Prof. Dr. Ir. Indra Nurhadi, NUHA

IMPROVEMENT OF AVAILABILITY AND MTBF (MEAN TIME BETWEEN FAILURE) OF MINING EQUIPMENT USING SIX M APPROACH (MANPOWER, MATERIAL, MACHINE, METHOD, MEASUREMENT, MOTHER NATURE)
由: Chrisostomus, Nicholas

IMPROVEMENT OF AVAILABILITY AND MTBF (MEAN TIME BETWEEN FAILURE) OF MINING EQUIPMENT USING SIX M APPROACH (MANPOWER, MATERIAL, MACHINE, METHOD, MEASUREMENT, MOTHER NATURE)
由: Chrisostomus, Nicholas

IMPROVEMENT OF AVAILABILITY AND MTBF (MEAN TIME BETWEEN FAILURE) OF MINING EQUIPMENT USING SIX M APPROACH (MANPOWER, MATERIAL, MACHINE, METHOD, MEASUREMENT, MOTHER NATURE)
由: Chrisostomus, Nicholas

EXPERT ELICITATION UNTUK MEMPREDIKSI MEAN TIME BETWEEN FAILURE (MTBF) KOMPONEN KRITIS BUS DENGAN DELPHI METHOD (Studi Kasus: Bus Rapid Transit Trans Jogja)
由: , NILA KHUSNIKA S, et al.
出版: (2013)

Centrifuge study of the effects of lattice leg on penetration resistance and bearing behavior of spudcan foundations in NC clay
由: Li, Yu Ping, et al.
出版: (2013)

STUDY OF TOPPLING FAILURE MECHANISM ON OVERALL SLOPE MODEL WITH CENTRIFUGAL TEST
由: IHSAN FADILAH (NIM : 12114009), FAKHRI

Bearing failure detection using matching pursuit
由: Liu, B., et al.
出版: (2014)

Classification of bearing failure in adverse industrial conditions
由: Bawar Masih
出版: (2024)

Community Development as and Effective Means of Raising the Thai Villager s Standard of Living
由: Pakorn Ansusingha
出版: (1960)

STUDY OF TOPPLING FAILURE MECHANISM ON OPEN PIT SLOPE MODEL WITH CENTRIFUGAL TEST
由: INDAH SAFITRI , ULFAH

STUDY OF TOPPLING FAILURE MECHANISM ON OPEN CAST SLOPE MODEL WITH CENTRIFUGAL TEST
由: SRI LESTARI (NIM : 12114032), WAHYUNI

Coal bottom ash as partial replacement of fine aggregates in hollow load-bearing concrete masonry units
由: Remigio, Joseph S.
出版: (2003)

SYMBOLIC MEANINGS OF CHINESE SPACE: THROUGH THE STUDY OF THE ARCHITECTURE IN MOVIE �RAISE THE RED LANTERN �
由: ONG CHIEW WAN
出版: (2017)

Listing standards : to raise or not to raise?
由: Huang, Sui., et al.
出版: (2013)

ANALISIS AWAL PEMANFAATAN LIMBAH BOTTOM ASH SEBAGAI PENGGANTI SEMEN DALAM CAMPURAN BETON
由: SUKMA WALUYO, NURHADI

Centrifugal Pumps
由: Johann Friedrich Gülich.
出版: (2017)

Centrifugal pumps
由: Alvara, Teodoro A.
出版: (1955)

A study on the use of bottom ash as partial substitute to fine aggregates in the mix design of concrete load-bearing hollow blocks
由: De Guzman, Marco Antonio A., et al.
出版: (2003)

Family functioning in Asian families raising children with autism spectrum disorders: The role of capabilities and positive meanings
由: Xue, J., et al.
出版: (2016)

DESIGNING 2D ANIMATION AS A MEANS OF RAISING AWARENESS OF REVENGE BEDTIME PROCRASTINATION FOR YOUNG ADULTS
由: Tsabita Fitriyani, Ananda

Current crowding effect on copper dual damascene via bottom failure for ULSI applications
由: Vairagar, A. V., et al.
出版: (2009)

A LABORATORY SCALE OF PHYSICAL MODELING OF SLOPE FAILURE GENERATED BY CENTRIFUGAL ACCELERATION WITH SEVERAL WATER CONTENT SCENARIOS
由: Wicaksana, Yudhidya

Fault frequency identification of rolling bearing using reinforced ensemble local mean decomposition
由: Qin, Bo, et al.
出版: (2022)

A comparative analysis of scaffold material modifications for load-bearing applications in bone tissue engineering
由: Chim, H., et al.
出版: (2011)

DESIGN AND PERFORMANCE SIMULATION END SUCTION CENTRIFUGAL PUMP CAPACITY 5 L/S AND HEAD 9 M
由: BUDIONO NAPITUPULU (NM : 13104163); Pembimbing Utama : Ir.Arianto Santoso, M.Sc,

Raising the Bar
由: WANG, Jiwei
出版: (2012)

Raising the Bar
由: WANG, Jiwei
出版: (2012)

The raising of Lazarus
由: La Viña, Antonio Gabriel M.
出版: (2023)

Structurally ordered porous materials from bottom-up self-assembly and transient Joule heating
由: Wang, Leyan
出版: (2023)

INFLUENCE OF HEIGHT TO THICKNESS RATIO VARIATIONS OF BLOCKS ON ROCK SLOPE TOWARDS TOPPLING FAILURE USING PHYSICAL MODELLING WITH CENTRIFUGE TEST
由: PARDOMUAN KARRE (NIM : 12113027), TIMOTHY

Microstructural study of bearing material failure due to rolling contact fatigue in wind turbine gearbox
由: Maharjan, Niroj, et al.
出版: (2020)

THERMODYNAMIC MODELING OF CENTRIFUGAL CHILLERS
由: KHIN MAUNG AYE
出版: (2020)

CENTRIFUGE MODELLING OF DEEP EXCAVATIONS
由: WEI JIE
出版: (2020)

Centrifuge modelling of pile foundation
由: Leung, C.F.
出版: (2014)

Studi evaluasi kinerja BAPPEDA Tingkat II Banjar dalam upaya pelaksanaan bottom-up planning
由: , MANTIR, Hardy L, et al.
出版: (1997)

Raising children of character
由: Tesoro, Mary Anne B.
出版: (2009)

Raising responsible "tweens"
由: Tesoro, Mary Anne B.
出版: (2008)

Raising a stranger
由: Ng, Caitlin Suyu, et al.
出版: (2024)

Failure analysis of double-row tapered roller bearing outer ring used in Coal Wagon Wheelset
由: Darmo, Suryo, et al.
出版: (2022)