Effect of EDF position on the performance of hybrid dispersion-compensating Raman/EDF amplifier

• Main Authors: Ali M.H., Abdullah F., Jamaludin M.Z., Al-Mansoori M.H., Al-Mashhadani T.F., Abass A.K.
• Other Authors: 56510302500
• Format: Conference paper
• Published: 2023
• Subjects: Erbium doped fiber amplifier; Hybrid fiber amplifier; Raman fiber amplifier; Stimulated Brillouin scattering; Bandwidth; Erbium doped fiber amplifiers; Fiber amplifiers; Fibers; Photonics; Erbium doped fibers; Flat-gain; Gain variations; Raman fiber amplifiers; Raman gain saturation; Small signal gain; Stimulated Brillouin Scattering (SBS); Amplifiers (electronic)
• Institution: Universiti Tenaga Nasional

The effect of the location of the Erbium-doped fiber (EDF) on the performance of the hybrid dispersion compensation of Raman/EDF amplifier is discussed in this study. Two different configuration set-ups were determined according to the position of the EDF amplifier. The setup in which EDF A is positioned before is denoted by type A, while type B denotes the setup in which EDFA is positioned after. In these two amplifier configurations, the Raman gain saturation due to the Stimulated Brillouin scattering (SBS) effect is included. Type B shows a better hybrid fiber amplifier (HF A) performance in terms of overall gain, noise figure (NF), and flatness gain profile. A small signal gain of 33 and 35 dB with a flat gain bandwidth of 40 nm is achieved for types A and B, respectively. In addition, type B exhibits a high peak gain of 23 dB, with gain variation of 3 dB along 70 nm bandwidth for large input signal compared with the 17 dB peak gain of type A with gain variation of 4.4 dB along the same bandwidth. � 2013 IEEE.