Investigation Of Optical Wireless For Employment Within A Vehicular Environment

• Main Author: Abdul Mutalip, Zaiton
• Format: Thesis
• Language: English
• Published: UTeM 2016
• Subjects: T Technology (General); TK Electrical engineering. Electronics Nuclear engineering
• Online Access: http://eprints.utem.edu.my/id/eprint/18847/1/Investigation%20Of%20Optical%20Wireless%20For%20Employment%20Within%20A%20Vehicular%20Environment%2024%20Pages.pdf; http://eprints.utem.edu.my/id/eprint/18847/; http://library.utem.edu.my:8000/elmu/index.jsp?module=webopac-d&action=fullDisplayRetriever.jsp&szMaterialNo=0000102289
• Institution: Universiti Teknikal Malaysia Melaka

The substantial increase in powerful electronic systems and functions has produced significant implications for the vehicular industry, where the amount of wiring infrastructure has increased the vehicle weight, weakened performance, and made adherence to reliability standards difficult. Eventually, connecting the electronics infrastructure was mostly complicated and costly in vehicular domain systems. Thus, little research has been conducted to explore appropriate wireless technologies that may be suitable with the emerging network standard within the context of vehicular networks. This thesis describes an in-depth investigation of deploying an optical wireless communication system within the vehicular environment, particularly in confined spaces. A wide variety of measurements has been performed using tubes of various materials and geometries, in a laboratory setup. The principle objective is to provide a primary knowledge of optical wireless channel characterization within a laboratory vehicular setting. The work presented is a study on directed line-of-sight (LOS) and non-LOS (NLOS) links, and focuses on frequency response, power efficiencies, and path losses in different experimental settings. Further, a variety of experimental settings was used in respect to different receiver/transmitter orientations and various bent tubes angles in order to investigate the channel conditions. The noise analysis, SNR, path loss and the eye pattern for the digital system prototype designed were also analysed. The system requirement for the LOS link were based on the transmission of the sinusoidal signal at a distance of 1 m with 13 MHz signal and approximately 15.6 dB SNR. Successful demonstration of the OWC within smaller size and high reflection coefficient material are promising. In addition to good transmitter and high sensitivity receiver. The NLOS link also demonstrated a good indication, both in straight tube with angled transmitter/receiver orientation and bend tubes. Detail studies on NLOS link with pulse signal transmission, which replicates a digital system transmission with 54.48 mW or 44.58 mW/cm2 output power,6 MHz signal transmission with the aim of 10-4 to 10-6 BER. Although, the operational functionality of digital system has successfully demonstrated, however achieving the desired BER is a bit difficult with the designed system. Further improvement on the highly sensitive receiver design, a proper modulation scheme is required in order to improve the quality of the transmitted signal in terms of SNR and BER. The study also suggested that the transmission within the metal tubes is better than in plastic tubes in addition to minimum bend angle, smaller tube diameter and high reflective coefficient. Transmission within 20 mm circular aluminium tube and 35 mm galvanised aluminium tube are the best so far. Finally, based on the initial viability results, it was seen that it is possible to implement an optical wireless communication infrastructure within the vehicular environment. Experimental validation of the system proposed shows that achieving high data rates is not a problem with the use of high brightness, high power LEDs as this system is going to be implemented within the vehicle chassis, thus the eye safety constraints should not be a limiting factor. Therefore, in this study, optical wireless transmission within the vehicular environment is proposed, solving the problems of vehicular networking systems.