Improvement of adhesive toughness measurement
The double cantilever beam (DCB) method for adhesive toughness measurement was improved by incorporating a sufficiently sharp crack made by a wedge-tapping method. A known route to producing cracks via loading–unloading cycles was proved unreliable because the cycles produced plastic deformation in t...
Saved in:
| Main Authors: | , , , , , , |
|---|---|
| Format: | Article |
| Language: | English |
| Published: |
Elsevier Science Ltd
2011
|
| Subjects: | |
| Online Access: | http://eprints.uthm.edu.my/4577/1/AJ%202017%20%28197%29%20Improvement%20of%20adhesive%20toughness%20measurement.pdf http://eprints.uthm.edu.my/4577/ http://dx.doi.org/10.1016/j.polymertesting.2011.01.001 |
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Institution: | Universiti Tun Hussein Onn Malaysia |
| Language: | English |
| Summary: | The double cantilever beam (DCB) method for adhesive toughness measurement was improved by incorporating a sufficiently sharp crack made by a wedge-tapping method. A known route to producing cracks via loading–unloading cycles was proved unreliable because the cycles produced plastic deformation in the adhesive where new cracks propagated. Abnormally high toughness values with large standard deviations were obtained with cracks made by embedding a non-sticky insert. Only instantly propagated cracks made by tapping were sufficiently sharp to produce reproducible, accurate tough-ness measurements. However, toughened resin was insensiti |
|---|