Vortex-induced vibrations of a neutrally buoyant circular cylinder near a plane wall

• Main Authors: Hao, Zhiyong, Wang, X. K., Tan, S. K.
• Other Authors: School of Civil and Environmental Engineering
• Format: Article
• Language: English
• Published: 2013
• Subjects: DRNTU::Engineering::Civil engineering
• Online Access: https://hdl.handle.net/10356/103042; http://hdl.handle.net/10220/16894
• Institution: Nanyang Technological University

This paper presents an experimental study of the motions, drag force and vortex shedding patterns of an elastically mounted circular cylinder, which is held at various heights above a plane wall and is subject to vortex-induced vibration (VIV) in the transverse direction. The cylinder is neutrally buoyant with a mass ratio ⁎m=1.0 and has a low damping ratio ζ=0.0173. Effects of the gap ratio (S/D) ranged from 0.05 to 2.5 and the free-stream velocity (U) ranged from 0.15 to 0.65 m/s (corresponding to 3000≤Re≤13 000, and 1.53≤⁎U≤6.62) are examined. The flow around the cylinder has been measured using particle image velocimetry (PIV), in conjunction with direct measurements of the dynamic drag force on the cylinder using a piezoelectric load cell. Results of the vibrating cylinder under unbounded (or free-standing) condition, as well as those of a near-wall stationary cylinder at the same gap ratios, are also provided. For the free-standing cylinder, the transition from the initial branch to the upper branch is characterized by a switch of vortex pattern from the classical 2S mode to the newly-discovered 2PO mode by Morse and Williamson (2009). The nearby wall not only affects the amplitude and frequency of vibration, but also leads to non-linearities in the cylinder response as evidenced by the presence of super-harmonics in the drag force spectrum. In contrast to the case of a stationary cylinder that vortex shedding is suppressed below a critical gap ratio (S/D≈0.3), the elastically mounted cylinder always vibrates even at the smallest gap ratio S/D=0.05. Due to the proximity of the plane wall, the vortices shed from the vibrating cylinder that would otherwise be in a double-sided vortex street pattern (either 2S or 2PO mode) under free-standing condition are arranged into a single-sided pattern.