Optimization of supercritical carbon dioxide based combined cycles for solid oxide fuel cell-gas turbine system: energy, exergy, environmental and economic analyses

• Main Authors: Pan, Mingzhang, Zhang, Ke, Li, Xiaoya
• Other Authors: School of Electrical and Electronic Engineering
• Format: Article
• Language: English
• Published: 2022
• Subjects: Engineering::Electrical and electronic engineering; Supercritical Carbon Dioxide Recompression; Brayton Cycle
• Online Access: https://hdl.handle.net/10356/160037
• Institution: Nanyang Technological University

Among various supercritical carbon dioxide cycles, the supercritical recompression carbon dioxide cycle can well adapt to the high temperature of the exhaust gas of the solid oxide fuel cell-gas turbine system to augment power generation. Nevertheless, even after the recovery by the supercritical recompression carbon dioxide cycle, the exhaust gas still contains a large amount of unutilized waste energy. Few studies introduce low-temperature cycles to build cascade cycle systems, which are very likely to address this issue effectively. From the perspectives of energy, exergy, environmental and economic indexes, this article analyzes and compares the improvement potential of integrating four common low-temperature cycles, including organic Rankine cycle, transcritical carbon dioxide cycle, Kalina cycle, and organic flash cycle. Different key operating parameters are considered in-depth and optimized by a genetic algorithm. The results illustrate that in terms of efficiency, the introduction of the organic Rankine cycle is the most outstanding since it can reach the highest energy efficiency of 72.74–73.55% (exergy efficiency of 70.22–71.01%) across wide operation conditions. In terms of cost, the coupling of Kalina cycle is suggested due to the lowest capital cost of 19.94 $/h. The environmental penalty of the four systems all accounts for 14.73% of the total cost. As a consequence, the pros and cons of four common low-temperature cycles are fully demonstrated, which can provide references for the power plant planning.