Effect of minimum quantity lubrication during micro-machining

Micro-machining has become one of the most successful and latest developments in precision engineering. There are many types of micro-machining in the manufacturing industries, and the main focus in this project will be on micro-turning. During machining operation, heat and friction often generate b...

Full description

Saved in:
Bibliographic Details
Main Author: Chen, Lixin
Other Authors: School of Mechanical and Aerospace Engineering
Format: Final Year Project
Language:English
Published: 2011
Subjects:
Online Access:http://hdl.handle.net/10356/45242
Tags: Add Tag
No Tags, Be the first to tag this record!
Institution: Nanyang Technological University
Language: English
Description
Summary:Micro-machining has become one of the most successful and latest developments in precision engineering. There are many types of micro-machining in the manufacturing industries, and the main focus in this project will be on micro-turning. During machining operation, heat and friction often generate between tools and chip in the cutting area, resulting in poor machining performance. Micro-machining operation is thus often more efficient with the use of lubrication or coolant. However, in the machining industries, coolants and lubricants are used in high quantities to reduce the temperature & friction at the cutting area. As a result, coolant in wet machining operations is a crucial economic issue. Therefore the interest has been switch to another alternative, machining with Minimum Quantity Lubricant (MQL), is gaining acceptance as a cost-saving and environmentally friendly option in place of some wet machining processes. Minimum Quantity Lubricant is actually a misnomer, as it does not refer to an optimal minimal quantity of lubricant. This is a standard term applied to low lubrication flow rate where almost 80% of benefit of flooded lubricant condition may be achieved. Under such condition the flow rate of lubricant is usually kept at few millimeters per hour rather than few liters per hour. This report presents a total of 48 micro-turning cutting operations based on Design of Experiment (DOE) methodology, conducted on 6 sets of wet cutting operation and 2 sets of dry condition cutting operation. The machining parameters varied in these experiments are the spindle velocity, feed rate and depth of cut. The aim of this experiment is to investigate the effect of Minimum Quantity Lubricant (MQL) on surface quality and the cutting forces, and predicting the optimum value for surface ii quality using machining parameters and amount of Minimum Quantity Lubricant (MQL).