Power inverter for high speed starter/generator in aircraft applications

• Main Author: Geng, Shen
• Other Authors: Su Rong
• Format: Final Year Project
• Language: English
• Published: 2016
• Subjects: DRNTU::Engineering
• Online Access: http://hdl.handle.net/10356/67693
• Institution: Nanyang Technological University

Over the recent years, advances in power electronics and electrical machines have permitted the use of the electric starter/generator directly coupled to the shaft of the gas turbine engine driven by the aerospace starter/generator to a self-sustaining speed in the start mode and later converter the mechanical energy of the turbine into electricity in the generator mode. The starter/generator have the following features. Its rated speed can reach as high as the speed of 50000 revolutions per minutes. The rated frequency of supply voltage can be as high as 1000 Hertz. Typically it has relatively few turns on the stator windings so that the currents can build rapidly under high speed operations. However, when the number of turns are reduced, the stator inductance becomes small so that the machine is sensitive to the harmonic distortion of the supply voltage of the machine. Due to the constrains of switching frequency of the inverter, the inverter will induce large current ripples for this high speed motor compared with conventional motor drive with the rated frequency of 50 Hertz. Increased current ripple leads to a high level of Total Harmonic Distortion (THD) in the stator current waveform. Therefore, the aim of this project is to implement a control system for the high speed starter/generator. The bulk of this finial year report will cover the study of the IGBT which is used to drive the motor, analysis of IGBT faults under the high speed switching, design and development of the control circuit for IGBT. Major development will include the Dead-time Generation, Over-Current Protection and so on. In addition to the theory, hardware testing and overall result will be shown as well. Based on the real time experiment, observation and recommendation will be suggested to improve the IGBT control system.