Wind tunnel testing of additive manufactured aircraft components

• Main Authors: Teo, Z. W., New, T. H., Li, Shiya, Pfeiffer, T., Nagel, B., Gollnick, V.
• Other Authors: School of Mechanical and Aerospace Engineering
• Format: Article
• Language: English
• Published: 2018
• Subjects: Additive Manufacturing; Wind Tunnel Testing; DRNTU::Engineering::Mechanical engineering
• Online Access: https://hdl.handle.net/10356/88740; http://hdl.handle.net/10220/46130
• Institution: Nanyang Technological University

Purpose ‒ This paper reports upon the physical distortions associated with the use of additive manufactured components for wind tunnel testing and procedures adopted to correct for them. Design/methodology/approach ‒ Wings of a joined-wing test aircraft configuration were fabricated with additive manufacturing and tested in a subsonic closed-loop wind tunnel. Wing deflections were observed during testing and quantified using image-processing procedures. These quantified deflections were then incorporated into numerical simulations and results were found to agree well with wind tunnel measurement results. Findings ‒ Additive manufacturing provides cost-effective wing components for wind tunnel test components with fast turn-around time. They can be used with confidence if the wing deflections could be accounted for systematically and accurately, especially at the region of aerodynamic stall. Research limitations/implications – Significant wing flutter and unsteady deflections were encountered at higher test velocities and pitch angles. This reduced the accuracy in which the wing deflections could be corrected. Additionally, wing twists could not be quantified as effectively due to camera perspectives. Originality/value – This paper shows that additive manufacturing can be used to fabricate aircraft test components with satisfactory strength and quantifiable deflections for wind tunnel testing, especially when the designs are significantly complex and thin.