Microstructural characterization and amorphous phase formation in Co40Fe22Ta8B30 powders produced by mechanical alloying

In this work, microstructural evolution and amorphous phase formation in Co40Fe22Ta8B30 alloy produced by mechanical alloying (MA) of the elemental powder mixture under argon gas atmosphere was investigated. Milling time had a profound effect on the phase transformation, microstructure, morphologica...

全面介紹

Saved in:
書目詳細資料
Main Authors: Stoica, Mihai, Taghvaei, Amir Hossein, Vaughan, Gavin, Ghaffari, Mohammad, Maleksaeedi, Saeed, Janghorban, Kamal
其他作者: School of Electrical and Electronic Engineering
格式: Article
語言:English
出版: 2013
主題:
在線閱讀:https://hdl.handle.net/10356/96803
http://hdl.handle.net/10220/11671
標簽: 添加標簽
沒有標簽, 成為第一個標記此記錄!
機構: Nanyang Technological University
語言: English
實物特徵
總結:In this work, microstructural evolution and amorphous phase formation in Co40Fe22Ta8B30 alloy produced by mechanical alloying (MA) of the elemental powder mixture under argon gas atmosphere was investigated. Milling time had a profound effect on the phase transformation, microstructure, morphological evolution and thermal behavior of the powders. These effects were studied by the X-ray powder diffraction (XRD) in reflection mode using Cu Kα and in transmission configuration using synchrotron radiation, transmission electron microscopy (TEM), scanning electron microscopy (SEM) and differential scanning calorimetry (DSC). The results showed that at the early stage of the milling, microstructure consisted of nanocrystalline bcc-(Fe, Co) phases and unreacted tantalum. Further milling, produced an amorphous phase, which became a dominant phase with a fraction of 96 wt% after 200 h milling. The DSC profile of 200 h milled powders demonstrated a huge and broad exothermic hump due to the structural relaxation, followed by a single exothermic peak, indicating the crystallization of the amorphous phase. Further XRD studies in transmission mode by synchrotron radiation revealed that the crystalline products were (Co, Fe)20.82Ta2.18B6, (Co, Fe)21 Ta2 B6, and (Co, Fe)3B2. The amorphization mechanisms were discussed in terms of severe grain refinement, atomic size effect, the concept of local topological instability and the heat of mixing of the reactants.