Interactivity and Trust as Antecedents of E-Training Use Intention in Nigeria: A Structural Equation Modelling Approach

by Alkali, A. U., Mansor, N. N. A.
Published 2017

Fabrication of high aspect ratio micro electrode by using EDM

by Elsiti, N.M., Noordin, M.Y., Alkali, A.U.
Published 2016

Finite element modelling of a pattern of temperature distribution during travelling heat source from oxyacetylene flame

by Alkali, A.U., Ginta, T.L., Abdul-Rani, A.M.
Published 2014

Thermal analysis of cryogenic machining of Mg alloy using FEM

by Danish, M., Ginta, T.L., Alkali, A.U., Yasir, M.
Published 2016

Experimental investigation and 3D finite element prediction of temperature distribution during travelling heat sourced from oxyacetylene flame

by Alkali, A.U., Ginta, T.L., Abdul-Rani, A.M.
Published 2015

Thermal analysis of cryogenic machining of Mg alloy using FEM

by Danish, M., Ginta, T.L., Alkali, A.U., Yasir, M.
Published 2016

Evaluation of chips formation of AISI 316L SS using precision end-milling

by Yasir, M., Ginta, T.L., Ariwahjoedi, B., Danish, M., Alkali, A.U.
Published 2016

Effect of cutting speed and feed rate on surface roughness of AISI 316l SS using end-milling

by Yasir, M., Ginta, T.L., Ariwahjoedi, B., Alkali, A.U., Danish, M.
Published 2016

Effect of cutting speed and feed rate on surface roughness of AISI 316l SS using end-milling

by Yasir, M., Ginta, T.L., Ariwahjoedi, B., Alkali, A.U., Danish, M.
Published 2016

Evaluation of chips formation of AISI 316L SS using precision end-milling

by Yasir, M., Ginta, T.L., Ariwahjoedi, B., Danish, M., Alkali, A.U.
Published 2016

Fundamental investigation on influence of external heat on chip formation during thermal assisted machining

by Alkali, A.U., Ginta, T.L., Abdulrani, A.M., Elsiti, N.M.
Published 2018

Study on the machinability of 316L stainless steel using flame assisted machining

by Alkali, A.U., Ginta, T.L., Abdulrani, A.M., Fawad, H., Danish, M.
Published 2016

Investigation of the temperature distribution on the tool and workpiece during cryogenic machining of mg alloy by finite element analysis

by Danish, M., Ginta, T.L., Wahjoedi, B.A., Yasir, M., Alkali, A.U.
Published 2016

Study of tool life of uncoated WC-Co insert during flame assisted machining of 316L stainless steel

by Alkali, A.U., Ginta, T.L., Abdulrani, A.M., Fawad, H., Yasir, M., Danish, M.
Published 2016

Towards low carbon universities in Nigeria: Agenda for green information technology

by Alkali, A. U., Abdul-Azeez, I. A., Mansor, N. N. A., Chikaji, A. I., Dodo, Y. A.
Published 2017