Low sintering temperature of lead magnesium niobate-lead titanate (0.9PMN-0.1PT) by adding oxide additives

This research work is aimed at lowering the sintering temperature of 0.9PMN-0.1PT ceramics by adding oxide additives. The oxides used for this purpose were Bi2O3 and Li2CO3 with various amounts, following the formula of xBi2O3+yLi 2CO3, where x+y = 10 mol% and x = 1, 3, 5 and the mixed oxide additiv...

وصف كامل

محفوظ في:
التفاصيل البيبلوغرافية
المؤلفون الرئيسيون: Pisitpipathsin N., Pengpat K., Eitssayeam S., Tunkasiri T., Sirisoonthorn S., Budchan S., Intatha U.
التنسيق: Conference or Workshop Item
اللغة:English
منشور في: 2014
الوصول للمادة أونلاين:http://www.scopus.com/inward/record.url?eid=2-s2.0-55949113286&partnerID=40&md5=70897ca0f9cc3cc364090731857b83f7
http://cmuir.cmu.ac.th/handle/6653943832/5459
الوسوم: إضافة وسم
لا توجد وسوم, كن أول من يضع وسما على هذه التسجيلة!
الوصف
الملخص:This research work is aimed at lowering the sintering temperature of 0.9PMN-0.1PT ceramics by adding oxide additives. The oxides used for this purpose were Bi2O3 and Li2CO3 with various amounts, following the formula of xBi2O3+yLi 2CO3, where x+y = 10 mol% and x = 1, 3, 5 and the mixed oxide additive powders were then added to the dried powder of 0.9PMN-0.1PT with 1 wt% concentration. An excess PbO content of approximately 3 wtadded to all compositions to compensate the lead loss. After that, the mixed powders were pressed into pellets and subsequently sintered to form the ceramic samples. The results showed that the sintering temperature of 0.9PMN-0.1PT ceramics could be lowered down from 1250°C to 900-1000°C by the addition of small amount of the oxide additives, where the optimum composition was found in the sample with x:y = 1:9 at sintering temperature of 1000°C. Moreover, the densification, dielectric and ferroelectric properties of this sample remain acceptable in particular uses, promising positive future for reduction of lead loss from electrical and electronic industries. © 2008 World Scientific Publishing Company.