ENERGY EFFICIENCY IMPROVEMENT IN GEOTHERMAL POWER PLANT WITH THE APPLICATION OF LOAD-BASED GAS REMOVAL SYSTEM AND COOLING WATER PUMP CONTROL SYSTEM
From a thermodynamic perspective, the operation of a Geothermal Power Plant (GPP) follows the Rankine cycle. Efficient electricity generation is achieved through the conservation of energy (enthalpy) of steam from the well to the generator, setting low condensation pressure to achieve maximum ene...
Saved in:
| 主要作者: | |
|---|---|
| 格式: | Theses |
| 語言: | Indonesia |
| 在線閱讀: | https://digilib.itb.ac.id/gdl/view/46423 |
| 標簽: |
添加標簽
沒有標簽, 成為第一個標記此記錄!
|
| 機構: | Institut Teknologi Bandung |
| 語言: | Indonesia |
| 總結: | From a thermodynamic perspective, the operation of a Geothermal Power Plant
(GPP) follows the Rankine cycle. Efficient electricity generation is achieved
through the conservation of energy (enthalpy) of steam from the well to the
generator, setting low condensation pressure to achieve maximum energy
conversion in the turbine, and minimal electricity consumption (house-load). In
almost all GPPs, condensation (condenser) pressure is maintained by the vacuum
ejector, which absorbs the accumulation of Non-Condensable Gas (NCG), namely
CO2 and H2S. Condensation effectiveness relies heavily on the availability of
cooling water, which depends on the performance of the cooling water circulation
pump. In general, GPPs are designed to work on base-load (100% capacity);
therefore, the performance of supporting equipment such as ejectors and pumps is
not sensitive to fluctuations in generation loads or changes in NCG content (percent
weight in total steam supply). This insensitiveness results in almost constant houseload
and ejector's motive steam consumptions.
In the operation of GPP X, the NCG content is only 35% of its design, while the
daily generation fluctuates below the base-load according to grid regulator
instructions. This dynamic operation provides an opportunity for energy efficiency
efforts through modification of the ejector system and cooling circulation pump to
be more adaptive to changes in load, which ultimately supports conservation of
steam reserves. Performance analysis and design of control systems for ejectors
and circulating cooling water pumps are the scopes of the thesis discussion that
performs option evaluation, which includes: regulating cooling water rate,
controlling motive steam flow, or the combination of both, and also physical
modification of the ejector.
|
|---|